Photogenic Professional Lighting PLR1000DR User Manual download pdf (Page 19)

During the “ir” display if you then press either of the 1/10 buttons you will display “rado”

pressing the 1/10 button again will display a studio “Su” and number 1 through 4. Studio

numbers are assigned with 1/10 buttons. NOTE: the “rado” is currently an internal-only

system and should not be used if you intend to use infrared controls. To close “rado”,

press the 1/10 button again until the display reads “ir” then press the _ UP button again.

The next display will be “Un 1” which is your light unit number 1 – 9 assignment. You

must re-set the unit number with the 1/10 adjustment buttons, or the default “Un 1” will

automatically be assigned. Once the unit number has been assigned press the _ up button

which allows the startup sequence to finish and save the new settings.

Diagnostic Display Codes:

Circuits that prevent catastrophic damage to your investment protect the Solair and

Voltage Smart Solair PowerLight units.

“Er-0” message means that an AC line power frequency problem has occurred.

This could be internal or in the power cable or outlet at the location. Try

turning the main power off wait for 5 seconds and turn power back on.

“Er-1” message means that an AC line power voltage problem has occurred.

This could be internal or can happen with voltage spikes and voltage fall-off in

the location power supply. Try turning the main power off wait for 5 seconds

and turn power back on.

“Er-3” message means over heating has occurred. This could be internal or by

exceeding the recommended flash frequency. (See flash rate chart) Once “Er-

3” is displayed a “COOL” mode is activated to cool off internal components.

This usually is caused by too many quick-discharges resulting in the

overheating of the unit’s circuits. (See flash rate chart) The unit counts down in

this COOL mode for approximately 4 minutes. This is an electronically timed

period and turning the power OFF will not shorten this period. Therefore, you

must leave the power ON during this COOL-DOWN cycle.

“- - - - “ message means a misfire has occurred. To reset press the test fire

button or turn the power OFF. If the “----“ continues, turn the unit off and have

service performed. Examine the flash tube for damage as this can cause this

misfire message to be illuminated.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Photogenic Professional Lighting PLR1000DR User Manual Page 19